The FORTY2 changed a lot between idea and delivery. At first, Gramm thought the device would resonate most with U.S. consumers — tailgaters and campers seeking off-the-grid recreation. But experts were most excited about what the FORTY2 could do in the developing world, where three billion people live without reliable electricity. If Peppermint’s device could power lights for working and learning after sunset, equipment for disaster relief, and refrigerators for penicillin, it could change lives.
Think of it: Lifesaving medicine could reach places it couldn’t go before. The device could also spark commerce in remote areas as entrepreneurs find ways to monetize free reliable power. To do the most good, Gramm realized the FORTY2 had to be robust. In a portable size, providing the spikes of intense power that refrigeration demands was a big engineering challenge.
Gramm set about assembling the talent, resources and relationships to put his vision to work. “Honestly all I had at this point was a bit of an idea, and a picture,” he said. Once engineers had honed the device as far as possible in CAD, Peppermint needed a physical prototype. “It was hard for anybody, including me, to truly appreciate size and scale when you’re looking at it onscreen,” Gramm said.
At three feet wide and likely to weigh 60 pounds, the FORTY2 required a seriously robust housing, complex and strong enough to hold all of its components. Fused Deposition Modeling™ (FDM) was the only 3D printing method that could deliver. The first full-scale prototype, built in a Fortus 3D Production System, revealed some of the design considerations that led to the FORTY2’s delightfully simple operation.
“It’s only when you see it in physical form that you realize the form and function should be the same,” Gramm said. For example, a power switch is unnecessary; just opening the FORTY2 turns it on. The Peppermint team also decided to make the whole device even smaller than intended after carrying the first prototype proved awkward. Gramm said if he had to do it all again, he’d use 3D printing even earlier in the process.